Moves the drawing pointer to a specific location without drawing
a line.
 GROUP=groupvalue
MIDPOINT=midpointvalue
SUBGROUP=subgroupvalue
 specify coordinates for HBAR and
VBAR charts from the GCHART procedure. Use these variables only with the
data coordinate systems 1, 2, 7, and 8.
 WHEN='B'  'A'
 specifies when to perform the move
in relation to other procedure output. See also WHEN Variable.

X=horizontalcoordinate
Y=verticalcoordinate
Z=depthcoordinate (PROC G3D
only)
XC='charactertypehorizontalcoordinate'
YC='charactertypeverticalcoordinate'
 specify the coordinates to which
the pen is to be moved. The Z variable can only be used with the G3D procedure.
 XSYS='coordinatesystem'
 specifies the coordinate system for
the X or XC variable. Use the XC variable only with XSYS='2'. See XSYS Variable for an explanation
of coordinatesystem.
 YSYS='coordinatesystem'
 specifies the coordinate system
for the Y or YC variable. Use the YC variable only with YSYS='2'. See YSYS Variable
for an explanation of coordinatesystem.
 ZSYS='coordinatesystem'
 specifies the coordinate system for
the Z variable. See ZSYS Variable
for an explanation of coordinatesystem.
Use MOVE to prepare for a DRAW command,
a BAR command, or programming functions.
Copyright 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.